Part: NDZ low-ride feedneck
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: NDZ low-rise feedneck (sized to fit a Revvi or gravity-fed hopper), introduced chiefly for the Impulse in 2002ish.
| |
|
Part: Circuit housing (cricket board)
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Stock circuit housing from 2002 (when cricket boards were introduced). The older housings were nothced differently for the green/amber board's switches.
| |
|
Part: Dwell button cover
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Dwell button cover for a cricket board / circuit housing combo. The small button inside the cover isn't included in the model.
| |
|
Part: Frame screw
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Impulse frame screw.
| |
|
Part: Voodoo bolt
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: Voodoo delrin bolt from SP.
| |
|
Part: NDZ stubby Equalizer bolt
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Short length "stubby" Equ bolt from NDZ.
| |
|
Part: NDZ bolt bearing
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Plastic bearing used in NDZ bolts.
| |
|
Part: NDZ bolt bearing spring
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Spring that compresses the bearing inside NDZ bolts.
| |
|
Part: NDZ bolt bearing spring set screw
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Set screw that holds the bearing spring in position with NDZ bolts (plastic set screw)
| |
|
Part: Stock bolt pin
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: Stock bolt pin
| |
|
Part: NDZ rounded bolt pin
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: NDZ rounded bolt pin.
| |
|
Part: Stock piston housing (2002 series)
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: 2002 piston housing. The older housings are functinoally compatible but airflow isn't as controlled.
| |
|
|
|
Part: Stock hammer
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: Stock aluminum hammer.
| |
|
|
Part: Stock valve poppet
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: Stock delrin valve poppet, used on all guns except for the preproductions.
| |
|
Part: Valve lock screw (2002 series)
File type: Inventor 10 part file (.ipt)
Created by: Ydna
Description: Stock valve lock screw. THe older ones had a flathead screwdriver slot instead of an allen wrench hex.
| |
|
|
Part: ANS JAckhammerII set screw
File type: Inventor 5 part file (.ipt)
Created by: Seth "Siress"
Description: Set screw for JackhammerII LPRs, this holds the LPR housing to the LPR mount.
| |
|
