Navigation:
Tech index -> CAD file post -> Centerflag HPA preset reg

Model for the screw-in preset Centerflag tank system. As part of most tank regulators, you'll also likely wish to use models for the QD nipple, gauge, burst disk, etc. which can be found in the generic parts page.

Part: Manifold File type: Inventor 2008 part file (.ipt) Created by: Ydna Description: Regulator manifold section, containing the input-side peripherals (fill nipple, gauge, etc). The reg bonnet screws onto the front of this and is locked down in place.

Part: Bonnet File type: Inventor 2008 part file (.ipt) Created by: Ydna Description: ASA bonnet, uses odd threads which are just a demo, not realistic (the thread spec is the same, but their shape is odd).

Part: Piston File type: Inventor 2008 part file (.ipt) Created by: Ydna Description: Regulator piston.

Part: Pin valve File type: Inventor 2008 part file (.ipt) Created by: Ydna Description: Pin valve to seal airflow. Has a small o-ring on the front, and a spring behind it (neither are included here).

Navigation:
Tech index -> CAD file post -> PBC Matrix LPR