Navigation:
My Markers -> Custom markers -> Junkyard Shocker

This is a Shocker that I assembled entirely from parts I repaired or stock parts I got in a trade or had lying around. I have about $150 put into this gun, give or take.
· SL Shocker body (Milled by Ryan of Logic Paintball, previously owned by Jedunnigan), it was damaged but I was able to repair it.
· Dynasty trigger with stripped pre and post travel screws, no magnet
· Damaged Predator SFT board (microchip came off, I installed a new one and got it reflashed).
· Stock eyes epoxied into the body, wires attach them to the upper board, which is missing the eye ribbon connector.
· Broken drill bit shaft for trigger pin
· Evil LPR
· Nerve frame (grinded, sawed, drilled, cut, and doused...the visible parts in the pictures look good, but everything on the inside is a mess).
· Scratched delrin bolt, repaired.
· Scratched delrin bolt sleeve, repaired.
· Stock high-rise, stripped out and epoxied into the body.

Later on, I used this marker to test out a unique bolt modification, which can be read about on this page in the custom work section.

Navigation:
My Markers -> Custom markers -> Junkyard Shocker