Navigation:
My Markers -> Recreational markers -> 2000 Angel

A somewhat old Angel....lots of stripped screws, bought used off ebay or something....I don't know where it came from. A friend of mine bought it but he didn't want it after a while, so I took it off his hands.
· 2000 Angel LCD (LCD board removed)
· Predator-Morlock board with Predator AFA v3.0 code
· Beam-break anti-chop eyes
· 3-mm green LED
· Tarantula manufacturing frame/trigger
· Some kind of bolt
· Some kind of feedneck
· Some kind of volumizer
... (you get the idea)
I installed a Predator board in this gun becuase the LCD board was very screwey and didn't like to charge. The gun functions sooooo much better with the new electronics...except for the occasional leak here and there...

Here is a view of the electronics. Everything is relocated, even the LED, using wire disconnects. I had to use a separate disconnect for the LED becuase Thomas didn't tell me he wanted it relocated to the body until after I had assembled the harness for the other body components (power switch, solenoid, eyes). So I used one of those small JST connectors that WDP uses.

Wire harness (not involving the LED).

A very nice trigger microswitch mounting plate made from carbon fiber.

The board install didn't go quite as planned becuase the LPR housing on the front of the body was completely stripped out, in fact the threads may have locked together. Eventually I was able to remove it, but by that time I had already installed the board and was forced to route the wiring on the outside of the gun. It's ugly....but it works fine.

Maybe someday I'll redo the wiring.

Navigation:
My Markers -> Recreational markers -> Angel