Grip panel screw - $0.75/ea
Replacement grip panel screws for any SP marker. Available in silver or black, in long length (stock grips) or short length (Hybrid grips). | |
|
|
Vision eye screw - $0.75/ea
Replacement Vision eye ribbon screw, used on a Shocker SFT, Impulse, and Nerve. | |
|
|
Private Label frame, rear frame screw - $1/ea
Replacement rear frame screw for a Tonton, Warped Sportz Dark, 06 Dynasty, or Nerve frame. | |
|
|
Solenoid manifold screw - $1/ea
Replacement solenoid manifold screws; these screws hold the manifold to the Shocker body. Please note Nerves use different screws for their manifolds. | |
|
|
Solenoid spacer screw - $3/ea
This long screw holds the solenoid to the solenoid manifold. This will work with any 2004+ Shocker using the stock or NDZ manifold. It will work with the newer Evolve manifolds, but the older ones [that came with their own screws] are threaded differently.
Out of stock. | |
|
Out of stock
until further
notice |
Body set screw - $1.60/ea
These are the body set screws used to seal the internal air passages on a Shocker body (there are four of them total). Replacements are useful if you lose one or more screws for your gun and need to replace it/them.
These are high quality black oxide set screws. Regular steel or stainless screws won't work. | |
|
|
0.05" High-torque allen wrench - $2.50/ea
This is a special allen wrench that is slightly oversized so it will fit as snugly as possible inside hex screw heads. This allows for the most torque to be applied to the screw and helps to avoid stripping them out. I suggest using one of these if you plan on removing the body set screws from your Shocker body, to disassemble it for anodizing or thorough cleaning. These allen wrenches have an extra long shape to allow for maximum leverage. | |
|
|
Vertical adapter screw - $1/ea
Replacement vertical adapter screw for a Shocker or Nerve. This will function with all vertical adapters currently available, as well as any LPR vertical adapter. | |
|
|
Vertical adapter lock washer - $0.50/ea
This lock washer is required to space out the vertical adapter screw with the adapter itself. This is needed for all vertical adapters and LPR vertical adapters currently available.
Please note, if you're using the Hybrid 15º angled vertical adapter, you will most likely require two of these screws if using the stock 1/2" screw. | |
|
|
Regulator set screw - $0.75/ea
Replacement set screw for the side of the Shocker and Nerve vertical Max-Flo. | |
|
|
Board/microswitch pin - $2.50/ea
Replacement pins that hold the board in place within the frame.
(These pins cost extra due to being more difficult to source than the powerswitch and vertical adapter ones...sorry).
Out of stock. | |
|
Out of stock
until further
notice |
Powerswitch actuator pin - $1/ea
Replacement magnetic pin that holds the transparent powerswitch actuator button inside the frame. | |
|
|
Vertical adapter pin - $1/ea
Replacement pin that prevents the vertical adapter from swiveling around. | |
|
|
